Digital ECO-NUM I/O


  • 1 - 3 = €448.00
  • 4 - 8 = €438.00
  • 9 - 15 = €428.00
  • 16 - 20 = €419.00
  • 21 and more = €410.00


€448.00 Excl. Tax

The ECO-MCC module has 24 programmable digital inputs/outputs. ECO-NUM communicates with the ECO-MCC by CAN and RF network connection. Each ECO-NUM has a unique address on 4 bytes UID (eg 5B9F). It is inscribed on the case and is useful for its configuration with the software. I/O are isolated by opto-couplers, which requires placing a separate power supply.
The CAN network comprises a galvanic isolation and a jumper can be configured to place a resistor on the ends of the bus. The jumper is available on the ECO-MCC module front.
The connectors are detachable and allow automatic wire insertion (no screw). This allows direct connection to ECO-REL module. A cable connection is available as an accessory.


The module has the following characteristics:

  • 24 programmable digital I/O (input/output)
  • I/O overvoltage protection
  • I/O isolation to 2500Vdc
  • Communication interface to CAN - RF networks
  • Galvanic isolation of the CAN network by an internal power supply
  • Radio Frequency Communication with ECO-xxx modules
  • Removable screwless insertion connectors
  • 12 ... 24V external power supply for I/O (independent of ECO-MCC)
  • I/O LED status display
  • DIN rail mounting

Dimensions econum

How to view the ECO-NUM module Inputs - Outputs status?

Each digital I/O is connected to a LED that indicates its condition. The LEDs are placed on the ECO-NUM module front. Lit LED = ON output or input closed.

How is the ECO-NUM module powered?

A power connector is provided on the front panel. You can put a voltage of 12 ... 24V, the maximum consumption is 0.2 A. The I/O are galvanically isolated which requires a different set from the ECO-NUM power module. If there are several ECO-NUM or ECO-REL, power can be shared.

How to connect the CAN network?

The CAN network is used to send commands and read the status of another ECO-xxx module. You can connect multiple ECO-xxx modules on the CAN network, therefore it is necessary to place a resistor at each end of the network (jumper closed). Other intermediary ECO-xxx modules should not have placed resistance (jumper open). The jumper is located on the front face of the ECO-NUM module.

How does the RF network function?

Each ECO-NUM module includes a radio frequency network. The product is standardized and the radiated power does not exceed the standard. In the case of a cabinet configuration, it is necessary to place a remote antenna.

How to configure the ECO-NUM module?

It's very simple, you download the ECO-NETWORK setup software. ECO-NUM modules are identified by their unique UID address. The programming interface is user friendly and comes down to scheduling objects on the screen without specific programming knowledge.

Go to up