ECO-REL relay output


  • 1 - 3 = €94.00
  • 4 - 8 = €92.00
  • 9 - 15 = €89.00
  • 16 - 20 = €87.00
  • 21 and more = €84.00


€94.00 Excl. Tax

ECO-REL is connected directly to the outputs of the ECO-NUM, ECO-NAI, ECO-NAO modules or the outputs of the ECO-CMC module. RJ45 type link connector facilitates implementation. Connection to the ECO-xxx module is direct by semi-rigid wires that can be inserted into the connector. The connecting cable is available in the accessories. Each ECO-REL module has 6 output relays.

An output contact is available for directly controlling a receiver. A Wagp type connector facilitates connection.


The module has the following characteristics:

  • 6 relays with normally open contact (NO)
  • Output contacts protection
  • Relay control voltage = 12Vdc
  • Permissible output voltage on contact = 250VAC
  • Maximum output power = 6A (non-inductive)
  • Isolation voltage = 5000 VAC
  • Lifespan = 20 million cycles
  • Temperature: -10 ° C to 60 ° C
  • Removable screwless connectors
  • No power supply
  • DIN rail mounting or wall-mount housing

Dimensions ecorel

How to view ECO-REL status?

On the front of the case, 6 LED display relay status, LED on = relay ON.

Are output contacts protected?

Yes, a component protects output contact against inductive loads. In addition, it meets the most stringent requirements for absorbing an overvoltage from indirect lightning. The maximum admissible voltage is 275V.

How to connect the ECO-REL module?

Relay control is done directly on the RJ45 connector. An RJ45 cable (8 wires) is connected to ECO-REL and the other end of the cable to a wire outlet which is connected directly to the removable insertion connector. To facilitate connections, there is a cable as standard in the accessory section. The ECO-REL module connects to the digital parts of ECO-NUM, ECO-NAI, ECO-NAO modules.

How do I fix ECO-REL module?

ECO-REL module can be placed on a standard DIN rail. A wall box version exists as well.

Go to up